Before Using For The First Time; Basic Operation - Gaggenau Ac250121 Gebrauchs- Und Montageanleitung

6 Before using for the first time

Before using for the first time

Configure the settings for initial start-up. Clean the appli-
ance and accessories.
6.1 Setting an operating mode
Your appliance is set to air extraction mode by default.
7 Basic operation

Basic operation

7.1 Switching on the appliance
Requirement: Align the remote control as precisely as
possible to the infrared receiver for the LED display.
Press to switch on the appliance.
The appliance starts at fan setting 2.
The LED for the set fan setting lights up in the LED
display.
7.2 Switching off the appliance
Switch the appliance off when you are not using it.
Press to switch the appliance off.
The appliance switches off. Any functions currently in
progress are cancelled.
7.3 Selecting a fan setting
Press or .
The LED for the set fan setting lights up in the LED
display.
7.4 Switching on intensive mode
If particularly strong odours or vapours develop, you
can use intensive mode.
so oft drücken, bis in der LED-Anzeige die LED 4
1.
für die Intensivstufe 1 leuchtet.
so oft drücken, bis in der LED-Anzeige die LED 5
2.
für die Intensivstufe 2 leuchtet.
After approx. 6 minutes, the appliance automatically
switches to fan setting 3.
7.5 Switching off intensive mode
To select a fan setting of your choice, press
7.6 Switching on intermittent ventilation
With interval ventilation, the ventilation switches on for
approx. 6 minutes every hour.
Note: In the Home Connect app, you can set the time
and fan setting individually.
1
Depending on the appliance specifications
Note: When using it in circulating-air mode, you require
additional accessories.
When using it in circulating-air mode, set the operat-
ing mode.
"Setting the saturation indicator", Page 28
Press
In the LED display, LED 6 flashes continuously, the
LED for the selected fan setting lights up on the appli-
ance.
As soon as the ventilation time ends, the LED for the
fan setting you have selected goes out. LED 6 contin-
ues to flash.
7.7 Switching off interval ventilation
Press
7.8 Switching on automatic mode
The optimum fan setting is set automatically using a
sensor.
Press .
In the LED display, LED 6 lights up for automatic
mode.
7.9 Switch off automatic mode
Press .
The appliance switches to the fan setting that was
previously set.
The ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
Automatic mode runs for a maximum of four hours.
7.10 Sensor sensitivity
In automatic mode, a sensor in the appliance detects
the intensity of the cooking odours and roasting odours.
Depending on the setting of the sensor sensitivity, the
.
optimum fan setting is automatically switched on.
If the sensor control reacts too weakly or too strongly,
you can change the setting for the sensor sensitivity.
Factory setting: 3
Lowest setting: 1
Highest setting: 5
The corresponding LED lights up in the LED display.
7.11 Setting the sensor sensitivity
Requirement: The appliance is switched off.
Press and hold
1.
Press
2.
To cancel the setting, press .
Before using for the first time en
.
.
1
and for approx. 3 seconds.
or to change the setting.
1
1
1
27