Scheppach DP18VARIO Original Bedienungsanleitung Seite 28

• 1x chuck
• 1x column
• 1x machine foot
• 1x crank handle
• 1x tapered mandrel
• • 1x drilling table holder 1x drilling table holder
• 1x roller support
• 1x operating manual
4. Proper use
The bench drill is designed for drilling in metal, wood,
plastic and tiles. Straight shank drills from 3 mm to 16
mm drill diameter can be used.
The device is only intended to be used for DIY purposes.
It was not designed for continuous commercial use.
The device is not intended for use by people under the
age of 16. Children under the age of 16 may only use the
device when supervised. The manufacturer is not liable for
damage caused by improper use or incorrect operation.
It is strictly forbidden to dismantle, modify or
change the purpose of the guards on the machine
or to fit other guards.
Please note that our equipment was not designed with the
intention of use for commercial or industrial purposes. We
assume no guarantee if the device is used in commercial
or industrial applications, or for equivalent work.
5. Safety instructions
m WARNING - Read all safety information, instruc-
tions, illustrations and technical data for this elec-
tric tool.
Failure to follow all instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "electric tool" used in the safety instructions refers
to mains-powered electrical tools (with a mains cable) and
battery-powered electrical tools (without a mains cable).
1. Work area safety
a. Keep your work area clean and well-lit.
Cluttered or dark areas invite accidents.
b. Do not operate power tools in explosive at-
mospheres, such as in the presence of flam-
mable liquids, gases or dust.
Power tools create sparks which may ignite the
dust or fumes.
28 | GB
c. Keep children and bystanders away while oper-
ating a power tool.
Distractions can cause you to lose control.
2. Electrical safety
a. Power tool plugs must match the outlet.
Never modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
b. Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of elec-
tric shock if your body is earthed or grounded.
c. Do not expose power tools to rain or wet con-
ditions.
Water entering a power tool will increase the risk
of electric shock.
d. Do not use the cable for another purpose, for
example, carrying or hanging the power tool or
pulling the plug out of the socket.
Keep the cable away from heat, oil, sharp edges
or moving device parts. Damaged or coiled cables
increase the risk of an electric shock.
e. If you work with an electric tool outdoors, only
use extension cables that are also suitable for
outdoor use.
Use of a cord suitable for outdoor use reduces the
risk of electric shock. Only use approved and ap-
propriately identified extension cables for use out-
doors. Only use cable reels in the unrolled state.
f. If operating a power tool in a damp location
is unavoidable, use a residual current circuit
breaker with a trigger current of 30 mA or less
to protect the power supply.
Use of an RCD reduces the risk of electric shock.
3. Personal safety
a. Stay alert, watch what you are doing and use
common sense when operating a power tool. Do
not use a power tool while you are tired or under
the influence of drugs, alcohol or medication.
A moment of carelessness when using electrical
tools can result in serious injuries.
b. Wear personal protective equipment and al-
ways safety goggles.
Protective equipment such as a dust mask, non-
skid safety shoes, safety helmet or hearing pro-
tection used for appropriate conditions will reduce
personal injuries.
www.scheppach.com