Scheppach PL75 Originalbetriebsanleitung Seite 23

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 57113 / VDE0113 not being observed
Note:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
This operating manual should help you to familiarise your-
self with your device and to use it for its intended purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig. 1a-10)
1. Handle
2. Front handle
3. Plunge release
4. On/off switch
5. Guide plate
6. Cutting depth adjustment screw
7. Cutting depth scale
8. Mitre adjustment screw
9. Mitre angle scale
10. 90 degree set screw
11. Saw blade
12. Suction port
13. Set screw for guide rail
14. Shaft interlock
15. Splinter protection
16 Flange
17 Saw blade locking screw
18 Set screw
19 Riving knife
20 Anti-tip device
3. Scope of delivery
• Plunge saw
• Anti-tip device (20)
• Splinter protection (15)
• Allen key
• Operating manual
4. Proper use
The machine complies with the applicable EC ma-
chinery directive.
The plunge saws are intended for sawing wood, wood-
like materials and plastics.
This power tool is intended and permitted for use by
instructed persons or skilled personnel only.
Only suitable saw blades (HM or CV saw blades) may
be used for the machine. HSS saw blades and cutting
wheels of any kind must not be used.
All other applications are expressly excluded and are
considered non-intended use.
The manufacturer or dealer assumes no liability for injuries,
losses or damage caused by unintended or improper use.
www.scheppach.com GB | 23