Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8.3 Warehousing
• Keep the machine packed in a dry place.
• Do not stack more than three units on top of each other.
• Do not place other heavy items on the packing.
9
DISPOSAL
This product complies with EU Directive 2002/96/EC and is registered according to WEEE (Waste Electrical
and Electronic Equipment).
10 CE CONFORMITY
Conformity
The product complies with the following EU Directives:
Machine:
2006/42/EC
Low Voltage:
2006/95/EC
EMC:
2004/108/EC
PED:
97/23/EC
EN-Directives:
EN 292-1, EN 292-2, EN 60335-1, EN 60335-2-75, EN 55014,
EN 61000-3, EN 61000-4, ENV 50141, EN 55104
11 TROUBLESHOOTING
Problem
Little or no crema on top of the
coffee
Sparse coffee dispensing, only
drop by drop
The machine is switched on, but
the machine does not work.
Bedienungsanleitung / Instruction manual Profitec Pro 500
WEEE Reg.-Nr.: DE 97592029
Possible cause
The grind is not fine enough
The coffee is too old.
There is too much chlorine in the
water.
The amount of ground coffee is
not enough.
The shower screen is dirty.
The grind is too fine.
There is too much ground coffee.
The orange control lamp is
switched off: there is not enough
water in the water tank.
Water was refiled, the orange
control lamp is switched off.
The water tank is not fixed
properly.
Troubleshooting
Use a finer grind setting.
Tamp the ground coffee more
firmly.
Use fresh coffee
Use a chlorine filter.
Use the right coffee amount:
Approx. 7 g – 9 g of coffee for
each cup.
Clean the brew group.
Increase the grind setting.
Tamp the ground coffee only
slightly.
Use approx. 7 g – 9 g of coffee for
every cup.
Refill water.
Switch on/off the machine.
Make sure that the floater in the
water tank is in the correct
position. (The side of the floater
with the magnet point should face
towards the inside of the machine.
The floater itself should be
inserted with the magnet point on
the upper part of
the floater side.)
Fix the water tank properly.
27
ENGLISH
Werbung
