Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.2.2
Programming the ECO mode
The ECO-Mode gives you the option to set a timer that will automatically switch off your machine. After the
last brewing process, the machine will start the timer. The timer will be running in the background and is not
visible. When the timer ends the machine will automatically turn off. To reactivate the machine, either press a
PID key or switch the machine off and on again.
1. Switch on the machine.
–
+
at the same time and "t1" will appear on the display
2. Press
and
–
button until you reach "Eco". Press
3. Press the
4. Now you can carry out the programming in steps of 30 min by pressing
–
and
. In order to leave the programming mode, wait a short time and the
menu will be left automatically.
5. After a short period the setting will be adapted and saved.
6.3 Preparing coffee
Use the portafilter with 1 spout and the correspondent filter (1 cup) for the preparation of 1 cup. Use the
portafilter with 2 spouts and the big filter (2 cups) for the preparation of 2 cups. Make sure that the filter is
firmly locked into the portafilter.
Fill the ground coffee into the filter (approx. 7 g) into the 1 cup-portafilter and approx. 14 g into the 2 cups-
portafilter. Compress the ground coffee with a tamper. Clamp the portafilter firmly into the brew group.
Place the cup under the spout of the portafilter (for the preparation of 2 cups, put 1 cup under each spout).
Move the brew group lever into the upper position. When the cup is filled, move the brew group lever into the
lower position.
The remaining pressure/water will be discharged into the drip tray by the lower part of the infusion cylinder.
The pump pressure can be read on the pump pressure gauge.
Advice: After the brewing process, the gauge will still indicate a certain amount of pressure. Only when
preparing another cup of coffee the buildup of pressure is visible again.
If the brew group lever is not moved into the lower position properly, hot water and grounds can squirt out of the
group while taking out the portafilter. This may cause injuries.
• Only freshly ground coffee allows for an optimal coffee result. Therefore, use a
professional coffee grinder.
• We recommend to use a stainless steel tamper with a diameter of 58 mm for optimum
tamping.
Bedienungsanleitung / Instruction manual Profitec Pro 500
+
to enter the Eco menu.
22
+
ENGLISH
Werbung
