Honda EM50IS Bedienungsanleitung Seite 67

STANDARD KIT PARTS
Wheel Kit Installation
Do not operate the generator without the wheel kit installed. The wheel
kit provides a clearance between the ground and the generator air
intake.
NOTE:
If the wheel kit is not installed, it may be possible for dirt and debris to
be drawn into the generator air intake, possibly causing generator
damage. Always operate the generator with the wheel kit installed.
1.Install the two wheels on the axle shaft using the 20 mm washers
and 4.0×28 mm cotter pins.
2.Install the axle assembly on the generator using four 8×16 mm
flange bolts.
3.Install the two stands on the under frame using four 8×16 mm
flange bolts.
TORQUE: 24–29 N·m (2.4–3.0 kgf·m, 17–22 lbf·ft)
8×16 mm
FLANGE BOLT (4)
STAND (2)
WHEEL (2)
8×16 mm
FLANGE BOLT (4)
INSIDE
IN
LONGER
AXLE SHAFT
20 mm WASHER (2)
4.0×28 mm
COTTER PIN (2)
65