Weller WX 1 Originalbetriebsanleitung Seite 23

Error messages and error clearance
Message/symptom
ϊТspХКвμ „ά ά ά
σШ НТspХКв ПuЧМtТШЧ НТspХКв τόό
OFF
Channel cannot be switched on
WXD 2:
No vacuum at desoldering tool
WXD 2:
IЧsuПiМТОЧt vКМuuЦ Кt НОsШХНО-
ring tool
WXA 2:
Hot air tool has no air
rear port
Does not function with Zero
Smog/ WHP/PC/ WFV 60A
front port
Does not function with Zero
Smog/ WHP/PC/ WFV 60A
www.valuetronics.com
Possible cause
„
Tool has not been detected
„
Tool defective
σШ ЦКТЧs suppХв vШХtКРО
„
„
Overload cut-out
„
Channel switched off
„
Vacuum not connected
„
Desoldering nozzle clogged
„
Compressed air not or
ТЧМШrrОМtХв МШЧЧОМtОН
„
Filter cartridge on desoldering
tool full
εКТЧ iХtОr ШЧ sШХНОrТЧР stКtТШЧ
„
full
„
Air hose not connected
„
Compressed air not or
ТЧМШrrОМtХв МШЧЧОМtОН
„
Robot output set to Stop/Go
„
Footswitch is on
Remedial measures
„
Check connection of tool to
device
„
Check connected tool
„
Turn on mains power switch
ωСОМФ ЦКТЧs suppХв vШХtКРО
„
„
Check device fuse
τЧХв ШЧО sШХНОrТЧР ТrШЧ МКЧ ЛО
„
operated.
„
Connect vacuum hose to
vacuum connection
„
Service desoldering nozzle
using cleaning tool
„
Connect compressed air to
compressed air connection or
check
ωСКЧРО iХtОr МКrtrТНРО ШЧ
„
desoldering tool full
ωСКЧРО tСО ЦКТЧ iХtОr ОХОЦОЧt
„
on the soldering station
„
Connect compressed air to
compressed air hose or check
„
Connect air hose of tool to
WXA 2 or check
„
Deactivate Stop & Go function;
Or use front RS 232 port
„
Deactivate Footswitch; Or use
rear RS 232 port
39