Configuration Of Robot Interface; Function Of The Dip Switch On The Interface; Configuration Of The Process Data Width - Fronius Ri Fb Inside/I Bedienungsanleitung

Configuration of robot interface

Function of the
DIP switch on
the interface
NOTE!
Risk due to invalid DIP switch settings.
This may result in malfunctions.
▶
▶
Configuration of
the process data
width
OFF
OFF
The process data width defines the scope of the transferred data volume.
The kind of data volume that can be transferred depends on
-
-
-
Every time you change the DIP switch settings, re-start the interface after-
wards. This is essential for the changes to take effect.
Interface re-start = disconnect and reconnect the power supply or execute
the corresponding function on the power source website (SmartManager).
Dip switch
8 7 6 5
OFF - -
ON - -
ON OFF - -
ON ON - -
the robot controls
the number of power sources
the type of power sources
- "Intelligent Revolution"
- "Digital Revolution" (Retro Fit)
Englisch (US)
The DIP switch on the robot interface
is used to configure:
- the process data width
- the node address/IP address
Factory default: all positions of the
DIP switch are in the OFF position.
This corresponds to the binary value 0.
4 3 2 1
- - - -
- - - -
- - - -
Scope dependent on bus module
- - - -
Configuration
Standard image
320 Bit
Economy image
128 Bit
Retro Fit
Not used
25