Quality Control And Inspections - Zarges R3 Bedienungs- Und Betriebsanleitung

en
12 Quality control and
inspections
Units produced are designed and manufactured
according to the standard(s) on the product label
(CE, ANSI, CSA, etc.). Product designs are vali‑
dated through conformity assessments required
according to the standard(s) to which the product
is labelled (Declaration of Conformity, Certificate
of Conformity, etc.). Quality control during pro‑
duction is completed by sampling a minimum of
three units per batch, prior to acceptance of the
batch, and validating dimensions and markings.
Samples are statically tested according to the
applicable standard before batches are accepted
or released. Outgoing products are inspected by
Quality Control, minimum 3 per order, for accep‑
tance validating markings, labels, packaging, and
documentation. The Module C2 procedure for an‑
nual product checks as stated in Regulation (EU)
2016/425 Annex VII is conducted by the notified
body AITEX (0161).
WARNING
It is essential to the safety of the end user that
the seller of this device include all instructions
pertaining to the proper use, maintenance and
inspection of the device in the language of the
country in which the product is to be sold.
17