Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1 Fill a household pot with enough water to cover these parts and place all
the parts in the pot. Let the water boil for 5 minutes. Make sure the parts
do not touch the sides and bottom of the pot.
2 Allow the water to cool down.
3 Gently remove the parts from the water. Leave the parts to air-dry on a
clean tea towel or drying rack.
4 Store the dry items safely in a clean, protected area until needed. Ensure
that the clean parts have air-dried completely before storing them to help
prevent germs and mold from growing.
The collection cup parts are microwave sterilizer safe and steam sterilizer safe.
Follow the instructions of the sterilizer manufacturer.
Using the breast pump
Note: The figure numbers mentioned below refer to the numbers of the
figures on the back foldout pages of this user manual.
Charging the breast pump
Fully charge the battery before you use the breast pump for the first time and
when the battery is low. Fully charging the battery takes up to 1.5 hours.
Use a power source (an adapter or a power bank) with a USB port, of 5 V direct
current/2 A or 10 W for your breast pump. Using a power source with lower
specifications might result in slow charging or being unable to pump while
connected to a wall socket.
1 Switch off the device (Fig. 2).
2 Insert the small plug of the USB cable into the motor unit and insert the
other end of the USB cable into a USB power source, e.g. adapter or laptop.
3 The battery lights light up one by one and then all go out: the battery is
charging (Fig. 3).
4 All 3 lights are steady on: the battery is fully charged (Fig. 4).
5 Remove the USB cable from the USB power source and pull the small plug
out of the motor unit.
Battery indicator light description
The battery indicator lights show the battery capacity.
-
Three lights are steady on: the battery is fully charged for approximately
5 pumping sessions.
-
Two lights are steady on: the battery is charged sufficiently for 2–3 sessions.
-
One light flashes slowly: the battery is charged sufficiently for maximum
1 session. Charging is needed soon.
-
First light flashes quickly: the battery is very low, the device will stop
operating soon. Charging is needed.
11
English
Werbung
