Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Drilling in wood
Use a wood drill with a lathe centre.
Deep holes: Use an auger bit.
Large-diameter holes: Use a Forstner bit.
Small screws can be screwed directly into soft
wood.
Belt clip
m
CAUTION! RISK OF INJURY!
Before hanging the product in the belt:
u
Push the rotation direction switch
the centre position (lock). This prevents
the product from being switched on
accidentally.
The belt clip
allows the tool to be hooked
[
9 ]
on belt or pocket.
˜ Cleaning and care
m
WARNING!
Always switch the product off, remove
the battery pack
product cool down before performing
inspection, maintenance and cleaning
work!
˜ Cleaning
Never allow fluids to get into the product.
The product must always be kept clean, dry
and free from oil or grease. Remove debris
from it after each use and before storage.
Regular and proper cleaning will help ensure
safe use and prolong the life of the product.
20 GB
to
5 ]
[
and let the
[
]
Clean the product with a dry cloth. Use a soft
brush for areas that are hard to reach.
In particular clean the air vents after every
use with a cloth and soft brush.
The vents must always be clear.
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be
harmful to its surfaces.
˜ Maintenance
Before and after each use, check the product
and accessories (e.g. accessory tools) for
wear and damage. If required, exchange
them for new ones as described in this
instruction manual. Observe the technical
requirements (see "Technical data").
˜ Repair
This product does not contain any parts that can
be repaired by the user. Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired.
˜ Storage
Push the rotation control switch
centre position to lock the on/off switch
Clean the product as described above.
Store the product and its accessories in a
dark, dry, frost-free, well-ventilated place.
to the
5 ]
[
.
6 ]
[
Werbung
