Werbung
Verfügbare Sprachen
Verfügbare Sprachen
˜ LED work light
This product is equipped with a LED work light
to illuminate the immediate working area to
[
]
improve visibility in poorly lit areas.
The LED work light
as soon as the product is switched on.
NOTE
The LED work light
u
additional approx. 10 seconds after
switching off the product.
˜ Trial run
NOTE
Always carry out a no-load trial run before
u
starting work and after every accessory
tool replacement. Switch the product off
immediately if the accessory tool is not
running smoothly, if considerable vibration
occurs or if you hear abnormal noises.
Before operating the product, check whether
the accessory tool is correctly positioned, i.e.
centred in the chuck
Screw bits are labelled according to their
dimensions and their shape. If you are
uncertain, always check whether the bit fits
tightly in the screw head without any free
play.
˜ Working instructions
Torque
Smaller screws/bits can be damaged if you
set the torque or rotational speed too high.
lights up automatically
[
]
stays on for an
[
]
.
1 ]
[
Hard screw joints (in metal)
Particularly high torque occurs, for example in
metal screw joints made using drive sockets.
Select a low rotational speed.
Soft screw joints (e.g. in soft wood)
Again, use a low rotational speed, e.g. to
avoid damaging the surface of the wood
upon contact with the screw head. Use a
countersink.
Drilling in wood, metal and other
materials
Use a high speed for drill bits with small
diameter and a low speed for drill bits with
large diameter.
Select a low speed for hard materials and a
high speed for soft materials.
Secure or fasten the workpiece in a clamp or
vice (if possible).
Mark the spot where you want to drill using a
centre punch or nail. Select a low rotational
speed when starting.
Pull the rotating drill bit from the hole
repeatedly to remove dust and chips and
clear the hole.
Drilling in metal
Use a metal drill (HSS). For optimum results,
cool the drill bit with cooling lubricant (cutting
oil). Metal drill bits can also be used to drill
into plastics. Start with a 3 mm diameter drill
bit and then increase the size until the desired
hole diameter is achieved.
GB
19
Werbung
