hillvert HT-HECTOR 420T Bedienungsanleitung Seite 30

7. Transmission belt cover
8. Cylinder housing (block)
9. Support
10. Transport handle
11. Transport handle joint
12. Outlet chute
13. Spout with adjustable angle
14. Loading hopper
3.2.
Preparing for use
APPLIANCE LOCATION
The machine should be used outside closed spaces, on a stable, level surface,
preferably on grass or on the ground. Do not place the machine on concrete,
tarmac on other hard surfaces, because chips and other residue ejected by the
machine may bounce off and cause a hazard.
Work conditions
Inspect the material which is to be shredded and make sure there is enough
space above the machine to load the material. It is recommended to choose a
place of work as close as possible to the place where the chips are used. This will
reduce the need to carry the processed material to a minimum.
Keep a safe distance from the chip discharge area. Ensure which all bystanders,
children, animals or valuables are also at a safe distance from the chip discharge
area.
ASSEMBLING THE APPLIANCE
EN