Minebea Intec Option Y2 Installations- Und Sicherheitshinweise Seite 7

§ Adjust the gap as needed.
If necessary, loosen the bolts that
attach the downholder.
Bolt size: M8; wrench size: 13.
§ Before the scale platform can be
raised to a vertical position, loosen
the stop bolts on the right and left.
Danger of damage to the stop
!
bolts! The rear stop bolts must be
disengaged!
§ Grasp the platform by the handles
and raise it to the vertical position.
Note:
Two persons are required for raising
the platform.
! Please observe the safety instruc-
tions, as there is a hazard of person-
al injury. Always wear safety gloves
while raising or lowering the
platform.
Warning: Danger of personal injury!
!
Do not stand or move beneath the
platform.
§ Turn the left and right stop bolts.
The bolts slide into the side plate
and secure the platform in the verti-
cal position.
$ The surface under the platform
can now be cleaned easily.
§ Install the pneumatic springs
(right and left) as shown in the
illustration.
Tighten the bolts (size M10;
wrench size: 17).
§ Following installation, return the
platform to the horizontal position.
§ Turn the rear stop bolts (right and
left). The bolts slide out of the side
plate and release the platform.
Danger of damage to the stop bolts!
!
The stop bolts must be disengaged!
§ Grasp the platform by the handles
and lower it to the horizontal
position.
Note:
Two persons are required for
lowering the platform.
Please observe the safety instruc-
!
tions, as there is a hazard of person-
al injury. Always wear safety gloves
while raising or lowering the plat-
form. Do not stand or move beneath
the platform.
§ The platform is now in the horizon-
tal position.
§ Place your foot on the right-hand
downholder to press the side plate
of the scale to the floor; repeat
this procedure on the left-hand side
as well.
§ Position the front stop bolts (right
and left) to fix the scale in position
and turn the lever.
§ Remove the right and left mounting
aids as follows:
Unscrew the four M8 bolts as shown
(wrench size: 13).
§ Hook the drive-on ramp onto the
right and left retainers.
Pallet Scale/Flat-bed Scale: Option Y2 7
7