UNIPRODO VANDER PRO Bedienungsanleitung Seite 89

EN
Pass the thread behind and over
the top end of the left looper (9-
A)
Then pull it downward gently so
that it will slip into the slot in
the looper (9-B)
Pick up the thread and pass it
through the hole in the end of
the looper 10.
Note: Use the tweezers
provided in the accessory set to
aid in threading the looper
The thread should be positioned
in the groove of the lower
looper.
Pull about 10cm (4in) of thread
through the looper and place it
over the top of the upper looper
and to the back of the throat
plate.
Threading the Right Needle (Green)
Thread the right needle as
indicated 1~8