Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1 ELECTRICAL SAFETY
INSTRUCTIONS
1
Before connecting the dispenser to the mains,
check that the voltage shown on the rating plate
matches your electricity supply. Connect the
dispenser to a single-phase supply through an
earthed socket as required by current regulations. If
the dispenser is to be disconnected from the power
supply using a single pole switch, the gap between
the contacts on this switch must be sufficiently wide
to guarantee full disconnection under category III
overload conditions.?
2
Do not use extension cables to connect the
appliance.
3
To avoid any risks, if the power cable is
damaged, it must be replaced by the manufacturer,
by an authorised technician or by a similarly
qualified person.
4
The dispenser is not suitable for outdoor use.
5
The dispenser must be installed in the upright
position and always handled with care. If, even
during transport, it has been positioned horizontally,
wait 4 hours after installation before starting.
6
Before
cleaning,
dispenser by removing the plug from the socket.
7
Always
disconnect
r e m o v i ng a ny o f t h e p a n e l s f o r c l e a ni n g o r
maintenance work.
8
This appliance must not be operated by
children.
9
Do not let children play with the appliance.
10
This appliance must not be used by persons
w i t h r e d u c e d p h y s i c a l , s e n s o r y o r m e n t a l
capabilities or with a lack of experience and
knowledge unless they have supervision or have
been trained regarding the safe use of the appliance
and understand the risks involved.
11
Only persons who know and have practical
experience of the appliance are permitted access to
the inner components of the dispenser, especially
when dealing with issues regarding safety and
hygiene.
2 HYGIENIC SAFETY INSTRUCTIONS
1
This appliance is intended exclusively for
domestic and similar use.
2
For the appliance to operate correctly, room
temperature must be between +5° and +32°C.
3
Use the appliance to cool the indicated liquids
only.
4
Do not introduce dangerous or toxic liquids to
the appliance.
16
always
disconnect
the
dispenser
before
3 TECHNICAL CHARACTERISTICS
Transparent
bowls
Capacity
of
approx.
Dimensions:
width
depth
height
Net weight, approx.
Gross weight, approx.
Hermetic compressor
Air-cooled condenser
Overload protector
the
Noise level lower than 70 dB (A)
IMPORTANT
Electrical characteristics: read the data on the
plate of each individual dispenser. This is
located at the bottom of the front panel,
behind the drip tray on the right. The serial
numbers of the devices (preceded by the
symbol #) are shown on the frame below.
Always refer to the data shown on the plate.
We reserve the right to amend this manual without
notice.
4 INTRODUCTION
Read this instruction booklet carefully in order to
familiarise yourself with all aspects of the dispenser.
Like all mechanical products, this machine will
require cleaning and maintenance. Good operation
can also be affected by any errors made by the
operator during disassembly and cleaning. For this
reason, in the case of daily operations such as
disassembly, cleaning, sanitising and reassembly, it
is important that the person using the dispenser is
aware of the procedures and can perform them
without making errors.
5 INSTALLATION
1
Remove the dispenser from the packaging,
which you should keep in case it is needed in the
removable
n
1
each
bowl,
l
6
cm
20
cm
48
cm
62
kg
27
kg
29
2
3
6
6
40
60
48
48
62
62
47
62
51
65
Werbung
