Parkside Performance PPHKSA 40-Li A1 Originalbetriebsanleitung Seite 43

8.­Confirm­the­successful­connection­with­
"Finish".­
The­device­is­now­listed­on­the­tab­
"At home"­and­can­be­selected.

If­you­have­already­connected­other­
devices­to­the­app:
4.­On­the­tab­ ­"At home",­select­the­
in the upper right. The app scans the
area­for­available­devices­and­indicates­
if­available­devices­have­been­found.­
If this is not the case, read on if

possible
5. Proceed as with

­If­a­list­of­available­devices­is­not­auto-
matically­suggested­to­you:
If the smart battery is not suggested auto-
matically,­follow­these­steps:
4.­On­the­tab­ ­"At home",­select­the­
in the upper right.
5.­Select­„Other"­in­the­bar­on­the­left.
6.­Select­"Lidl Smart Battery".
7. Follow the instructions in the app.

If­you­have­already­connected­the­
smart­battery­to­the­app:
4. Select the tab
5.­Select­the­smart­battery­(that­you­are­us-
ing­for­the­device).­The­symbol­indicates­
that the smart battery is connected to a
Performance­device.
Upgrading­the­firmware­can­change­
the features of the app.
Features of the app
Select the smart battery that you are
using­for­the­device.­This­takes­you­to­the­
.

­from­point 5.
­"At home".
overview­page­for­the­device­with­the­
following­information­and­settings:
If you are not immediately directed to
the­overview­page­of­the­device,­se-
lect­the­Performance­device­under­"Device­
information"­on­the­overview­page­of­the­
battery.
-­ The­Tool Virtual ID helps you identify the
exact­tool
-­ The­Tool Model is indicated along with
the production batch in brackets
-­ The­Tool Discharge Current indicates the
current discharge in amperes
-­ The­Tool Rotation Speed indicates the
revolutions­per­minute
-­ The­working­modes­"Power"­and­"ECO"­
can­be­selected­via­Tool in Working
Mode.
-­ The­Current Level­indicates­which­level­
the tool is currently in. It can be changed
by selecting it.
-­ the­Lamp Switch­activates­or­deactivates­
the tool lighting.
-­ the­Tool Illumination Brightness can be
set
-­ the­Tool Illumination Delay can be set
-­ The­Tool Total Runtime can be read out
-­ The­frequency­of­the­overtemperature­
times­can­be­read­out­via­Tool
Overtemperature Times
-­ The­frequency­of­the­Tool Lock Times can
be read out
-­ The­frequency­of­the­Tool Overcurrent
Times can be read out
-­ A­red­dot­next­to­the­Firmware Version
indicates­if­an­update­is­available.­The­
update can be installed by tapping the
firmware­version
For­the­update,­also­read­the­"Up-
dating­the­firmware­version"­sec-
tion.
GB MT
43