Adjusting The Cutting Depth; Working Instructions - Parkside Performance Pphksa 40-Li A1 Originalbetriebsanleitung

1.­ Loosen­the­wing­screws­(11a+b)­of­the­
cutting angle preselection at the front
and­rear­of­the­device.
2. Set the desired angle on the cutting an-
gle­scale­(10).­
3.­ Tighten­the­wing­screws­(11a+-b)­again.
Turn­the­adjusting­knob­(36)­to­vary­
the cutting angle stop between 45°
and 48°.
­Hold­the­device­firmly­with­both­
hands during the angle cut to main-
tain better control of the tool.
Adjusting the cutting
depth
1.­ Loosen­the­locking­lever­(6)­by­pressing­
it upward.
2. Set the desired cutting depth on the cut-
ting­depth­scale­(4).
For a clean cut, select a cutting
depth­that­is­approx.­3­mm­
greater than the material thick-
ness.
3.­ Press­the­locking­lever­(6)­back­down­
to lock.

Working instructions

Sawing (without guide rail)
Right angle sawing
• Hold the machine with both hands, one
hand­on­the­handle­(3)­and­the­second­
on­the­auxiliary­handle­(13).
•­ Switch­on­the­device,­see­chapter­
"Switching­on/off"
• Place the machine with the front part of
the­baseplate­(7)­on­the­workpiece.
•­ Saw­forward­with­moderate­pressure­–­
never­backward.
Mitre cuts up to 45°
• Set the desired cutting angle as described
in­the­chapter­"Setting­the­cutting­angle".
• Hold the machine with both hands, one
hand­on­the­handle­(3)­and­the­second­
on­the­auxiliary­handle­(13).
•­ Switch­on­the­device,­see­chapter­
"Switching­on/off"
• Place the machine with the front part of
the­baseplate­(7)­on­the­workpiece.
•­ Saw­forward­with­moderate­pressure­–­
never­backward.
Moving­sideways­during­the­cut­
can­cause­the­saw­blade­to­jam,­re-
sulting in kickback.
Sawing (with guide rail)
Guide rail not included, but option-
ally­available,­e.g.­saw­rail­from­
Parkside PTSZ 70 A1.
Right angle sawing
• Place the guide rail on the workpiece
with the black rubber lip facing down-
wards­and­fix­the­guide­rail­to­the­
workpiece.
•­ Place­the­device­with­the­groove­on­the­
guide­rail­(37).
• Hold the machine with both hands, one
hand­on­the­handle­(3)­and­the­second­
on­the­auxiliary­handle­(13).
• The saw blade must not touch
the workpiece when switched
on!
­ Switch­on­the­device,­see­chapter­
"Switching­on/off"
•­ Saw­forward­with­moderate­pressure­–­
never­backward.
Mitre cuts up to 45°
• Place the guide rail on the workpiece
with the black rubber lip facing down-
GB MT
41