Parkside Performance PBSPA 12 E4 Bedienungsanleitung Und Originalbetriebsanleitung Seite 43

˜ Speed control
By using the on/off switch
o
can progressively control the speed:
Pressure
Gentle pressure:
Greater pressure:
˜ LED work light
This product is equipped with a LED
work light to illuminate the immediate
[ ]
working area to improve visibility in
poorly lit areas.
The LED work light
o
automatically as soon as the product
is switched on.
NOTE
The LED work light
u
an additional approx. 10 seconds
after switching off the product.
˜ Working instructions
Torque
Smaller screws/bits can be damaged
o
if you set the torque or rotational
speed too high.
Hard screw joints (e.g. in soft metal)
High torque occurs in hard screw
o
joints. Select a low rotational speed.
Soft screw joints (e.g. in soft wood)
Again, use a low rotational speed,
o
e.g. to avoid damaging the surface
of the wood upon contact with the
screw head. Use a countersink.
Small screws can be screwed directly
o
into soft wood.
, you
[ 8 ]
Speed
Lower speed
Higher speed
lights up
[ ]
stays on for
[ ]
Drilling in wood, metal and
other materials
Use a high speed for drill bits with
o
small diameter and a low speed for
drill bits with large diameter.
Select a low speed for hard materials
o
and a high speed for soft materials.
Secure or fasten the workpiece in a
o
clamp or vice (if possible).
Mark the spot where you want to drill
o
using a centre punch or nail. Select a
low rotational speed when starting.
Pull the rotating drill bit from the hole
o
repeatedly to remove dust and chips
and clear the hole.
Drilling in metal
Use a metal drill (HSS). For optimum
o
results, cool the drill bit with cooling
lubricant (cutting oil). Metal drill bits
can also be used to drill into wood
and plastics. Start with a small
diameter drill bit and then increase
the size until the desired hole
diameter is achieved.
Drilling in wood
Use a wood drill with a lathe centre.
o
Deep holes: Use an auger bit.
Large-diameter holes: Use a Forstner
bit.
Small screws can be screwed directly
into soft wood.
˜ Cleaning and care
WARNING!
m
Always switch the product off,
remove the battery pack
and let the product cool down
before performing inspection,
maintenance and cleaning work!
[ ]
GB/IE 41