WARNING!
m
Always switch the product off,
remove the battery pack
and let the product cool down
before making any adjustments!
CAUTION! Risk of injury!
m
Keep your hands away from the
u
accessory tool when the product is
in operation.
After the product has been
u
switched off, the accessory tool
continues moving for some time.
Do not touch the accessory tool
and do not attempt to brake it.
(Fig. C)
This product is equipped with an
automatic spindle lock to open or close
the chuck
with the chuck ring
[
1 ]
1. Open the chuck
ring
in a counter-clockwise
[
2 ]
direction.
2. Insert a suitable accessory tool into
the chuck
as deep as required.
[
1 ]
3. Close the chuck
accessory tool in position. Turn
the chuck ring
2 ]
[
direction.
Removing/installing the
chuck
NOTE
If you want to use the bit
u
adaptor
(see "Using the bit
[
]
adaptor"), you must first remove the
chuck
.
[
1 ]
(Fig. H)
Removing the chuck
1. Hold the chuck
[
]
.
2 ]
[
: Turn the chuck
1 ]
[
: Hold the
1 ]
[
in a clockwise
from the front.
1 ]
[
2. Pull the lock ring
unlock the chuck
3. Pull the chuck
1 ]
[
adaptor
.
[
]
Installing the chuck
NOTE
If the chuck
u
1 ]
[
adaptor
do not properly engage,
[
]
the lock ring
[
3 ]
to its initial position. In this case,
rotate the chuck clockwise or
counter-clockwise until the lock ring
returns back to its initial position
with a click sound.
1. Pull the lock ring
2. Align the hole of the chuck
the bit adaptor
[
3. Push the chuck
adaptor
as far as it will go.
[
]
4. Release the lock ring
chuck
.
[
1 ]
Using the bit adaptor
NOTE
If you want to use the bit
u
adaptor
, you must first remove
[
]
the chuck
(see "Removing/
1 ]
[
installing the chuck").
Insert a suitable screw bit into the bit
o
adaptor
as far as it will go. The
[
]
screw bit is held in place by a magnet
at the bottom of the bit adaptor.
To remove the screw bit, pull it out of
o
the bit adaptor
[
backwards to
3 ]
[
.
[
1 ]
off the bit
and the bit
cannot return back
backwards.
[
3 ]
with
[
1 ]
.
]
onto the bit
1 ]
[
to secure the
[
3 ]
.
]
GB/IE
39