KPS DCM300MINI Benutzerhandbuch Seite 3

DCM300MINI
and if the metal wire is bare.
1.1.5 Use the probe provided with the meter to ensure
safety. If necessary, replace the probe with another
identical probe or one with the same level of performance.
1.2 Usage
1.2.1 When using, select the right function and measuring
range.
1.2.2 Don't measure by exceeding indication value stated
in each measuring range.
1.2.3 When measuring a circuit with the meter connected,
do not touch the probe tip (metal part).
1.2.4 When measuring, if the voltage to be measured is
more than 60 V DC or 30 VAC (RMS), always keep your
fingers behind finger protection device.
1.2.5 Do not measure voltage greater than 600V DC or
AC(RMS).
1.2.6 In the manual measuring range mode, when
measuring an unknown value, select the highest
measuring range first.
1.2.7 Before rotating the knob switch to change measuring
function, remove probe from the circuit to be measured.
1.2.8 Don't measure resistor, capacitor, diode and the
circuit that is connected to power source or mains.
1.2.9 During the test of currents, resistors, capacitors,
diodes and circuit connections, be careful to avoid
connecting the meter to a voltage source.
1.2.10 Do not measure capacitance before capacitor is
discharged completely.
1.2.11 Do not use the meter in explosive gas, vapor or
dusty environments.
1.2.12 If you find any abnormal phenomena or failure on
the meter, stop using the meter.
1.2.13 Unless the meter bottom case and the battery
cover are fastened completely, do not use the meter.
1.2.14 Don't store or use the meter in the conditions of
direct sunlight, high temperature and high humidity.
2
EN