Scheppach PM1200 Original Bedienungsanleitung Seite 22

Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage. Electrical connection cables must comply
with the applicable VDE and DIN provisions, and the
local power supply regulations. Only use connection
cables marked with H07RN. The printing of the type
designation on the connection cable is mandatory.
AC motor
• The mains voltage must be 220-240 V/50 Hz.
• Extension leads up to 25 m long must have a mini-
mum cross section of 1.5 mm², and over 25 m long
must have a minimum cross section of 2.5 mm².
• The mains connection must be protected with a
max. 16 A fuse.
Connections and repair work on the electrical
equipment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
• Engine manufacturer; engine type
• Type of current for the motor
• Data of machine type plate
• Electrical control data
•
Connection type X
If the mains connection cable of this device is dam-
aged, it must be replaced by a special connection ca-
ble which can be obtained from the manufacturer or
its service department.
14. Troubleshooting
Problem Possible causes
Engine, cable or connector defective,
Engine does not run.
fuses burnt.
Engine does not Circuits in the network are overloaded
reach full power. (lamps, other engines, etc.)
Motor overheats Overloading of the engine, insufficient
easily. cooling of the engine.
22 | GB
13. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories
are made of various types of material, such as
metal and plastic. Defective components must
be disposed of as special waste. Ask your dealer or
your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point. This can
be done, for example, by returning it when purchasing
a similar product or delivering it to an authorised collec-
tion point for the recycling of old electrical and electron-
ic devices. Improper handling of waste equipment may
have negative consequences for the environment and
human health due to potentially hazardous substances
that are often contained in electrical and electronic
equipment. By properly disposing of this product, you
are also contributing to the effective use of natural re-
sources. You can obtain information on collection
points for waste equipment from your municipal admin-
istration, public waste disposal authority, an authorised
body for the disposal of waste electrical and electronic
equipment or your waste disposal company.
Remedies
Have the machine checked by a specialist.
Never repair the engine yourself. Attention!
Check the fuses and replace them if necessary.
Do not use any other devices or engines on the
same circuit.
Avoid overloading the engine during mixing and
remove dirt from the engine to ensure optimum
engine cooling.
www.scheppach.com