Silvercrest SSRA1 Bedienungs- Und Sicherheitshinweise Seite 38

Cleaning and storage
Set the power switch
ing the product.
Unplug the mains lead
before cleaning the product.
Do not rinse the product directly with water.
Do not wipe the product with a cloth soaked
in water.
Disconnect the power supply if the product will
not be used for an extended period.
Part Cleaning intervals
Dust collector Depends on usage
17
Primary, HEPA Weekly, 2 x weekly if very dirty
filter
6
Every 4 weeks
Side brushes
20
Combo floor Weekly, 2 x weekly if very dirty
brush
19
Anti-drop Every 2 weeks
sensors
21
Front wheel Every 4 weeks
22
Cleaning the dust collector and filter
Press the "Dust collector" button
the dust collector
17
Open the dust collector
and opening the cover
Now you can empty the contents over a dustbin.
Then begin by removing the main filter
can pull this out using the two handles.
Remove the HEPA filter
together by pulling the HEPA filter
the tab.
Now the dust collector
can be cleaned with water.
Reason
Left wheel malfunction
18
Right wheel malfunction E12
18
Left brush malfunction
20
Right brush malfunction E14
20
Combo floor brush
19
malfunction
38 GB/IE
to "O" before clean-
9
from the mains socket
4
and remove
11
from the product.
by pressing the tab
17
upwards.
24
. You
25
and the foam filter
6 26
out using
6
and the main filter
17 25
Display Signal tone
E11 Beeps: once
Beeps: once
Beeps: once
E13
Beeps: once
Beeps: once
E15
The HEPA filter and the foam filter
6
cleaned by tapping. Do not wash these with water.
To reinsert the filters
collector , perform this process in reverse
17
order.
Please make sure that all parts are fully dry
before inserting them.
Cleaning the brushes
Remove the combo floor brush
any hair or dirt.
Pull the side brushes
and remove any hair and dirt.
Cleaning the main housing
Clean the front castor
tangled in it.
Clean the 3 anti-drop sensors
their sensitivity.
Clean the anti-collision sensor
its sensitivity.
Cleaning the charging dock
Clean the charging contacts
of the robot vacuum cleaner and the charging
dock with a dry cloth.
Troubleshooting
If the product is not working correctly, the display
will show various error codes and emit different length
beeps. Please refer to the table below for trouble-
shooting
Solution
Check left wheel
Check right wheel
Check left brush
Check right brush
Check combo floor brush
can be
26
, , and the dust
6 25 26
and remove
19
out with a little force
20
to remove any hair
22
to maintain
21
to maintain
23
on the underside
3
18
18
20
20
19
1