Scheppach C-CDTB74/1-X Originalbetriebsanleitung Seite 22

WARNING
In case of extended working periods, the operating per-
sonnel may suffer circulatory disturbances in their
hands (vibration white finger) due to vibrations.
Raynaud's syndrome is a vascular disease that causes
the small blood vessels on the fingers and toes to
cramp in spasms. The affected areas are no longer
supplied with sufficient blood and therefore appear ex-
tremely pale. The frequent use of vibrating products can
cause nerve damage in people whose circulation is im-
paired (e.g. smokers, diabetics).
If you notice unusual adverse effects, stop working im-
mediately and seek medical advice.
ATTENTION
The product is part of the 20V IXES series and may on-
ly be operated with batteries of this series. Batteries
may only be charged with battery chargers of this se-
ries. Observe the manufacturer's instructions.
WARNING
Follow the safety and charging instructions
and correct usage given in the instruction
manual of your 20V IXES Series battery and
charger. A detailed
charging process and further information are
provided in this separate manual.
6 Technical data
Cordless impact drill
Engine voltage
Idle speeds n
0
• Gear 1
• Gear 2
Stroke rates
• Gear 1
• Gear 2
Max. torque
Chuck span Ø
Weight (without battery)
Drilling diameter for wood
Drilling diameter for steel
Battery charger
Input
Rated voltage
Rated power consumption
Fuse (internal)
22 | GB
description of the
C-CDTB74/1-X
20 V
0 - 400 rpm
0 - 1550 rpm
0 – 6000 rpm
0 – 22500 rpm
50 Nm
1.5 - 13 mm
1.34 kg
max. 30 mm
max. 13 mm
SBC2.4
230 – 240 V~
50 Hz
65 W
3.15 A
www.scheppach.com
Output
Rated voltage
Rated current
Protection class
Loading time:
2 Ah
4 Ah
Battery (Li-Ion)
Number of battery cells
Rated voltage
Capacity
Power
Max. temperature.
Charging process temperature
Operation temperature
Storage temperature
Subject to technical changes!
Noise and vibration
WARNING
Noise can have serious effects on your health. If the
machine noise exceeds 85 dB, please wear suitable
hearing protection for you and persons in the vicinity.
The noise and vibration values have been determined in
accordance with EN 62841-1.
Noise data
Sound pressure L
pA
Measurement uncertainty K
Sound power L
wA
Measurement uncertainty K
Vibration parameters
Hammer-drilling
Vibration a
h
Measurement uncertainty K
Drilling
Vibration a
h
Measurement uncertainty K
The total vibration emission values specified and the de-
vice emissions values specified have been measured in
accordance with a standardised test procedure and can
be used for comparison of one electric tool with another.
The total noise emission values specified and the total vi-
bration emission values specified can also be used for an
initial estimation of the load.
21.5 V
2.4 A
II (Double insulation)
approx. 60 min
approx. 120 min
SBP2.0
max. 20 V
2.0 Ah
40 Wh
50°C
4 °C – 40 °C
-20 °C – 50 °C
0 °C – 45 °C
84.3 dB
5 dB
pA
92.3 dB
5 dB
wA
8.417 m/s
1.5 m/s
4.170 m/s
1.5 m/s
5
2
2
2
2