HellermannTyton Autotool System 3080 Montageanleitung Seite 10

5 .1 .5 Adjusting spikes
1
2
f Unscrew clamping screw
f Set spikes to the desired height for the material to be
1
bundled.
f Tighten clamping screw
5 .1 .6 Connecting the ATS3080 and Bench mount kit
automatic 3080
5
4
To connect the ATS3080 and the Power pack 3080, observe
the ATS3080 operating instructions.
f Connect the ATS3080
5
à "Connection plan" on page 18
f Connect the power supply, à "Interface overview, Power pack
3080" on page 15
f Connect control boxes
3
control unit, à "Interface overview, control boxes" on
page 17
Assembly instructions Bench mount kit automatic 3080 • 03-2017 • v02 • 102-01012
.
2
.
2
Po we
r
Sig
na
l
to the Power pack 3080 ,
2
to the customer-supplied
f Connect compressed air connection
compressed air supply system.
f Make sure that all the wiring is free of kinks.
f Check that compressed air connection
leak-tight.
f Make sure that there is nothing to obstruct accessibility
to ATS3080 , Power pack 3080
5
and reel holders
5 .1 .7 Inserting the BMK closure chain guide
1
3
f Pull out locking pin
f Insert holder of closure chain guide
1
f Allow locking pin
1
5 .1 .8 Inserting the closure reel
1
2
8
7
3
6
f Remove closure reel
the protective mesh.
f Push in sleeve
6
inward.
f Insert closure reel
position in this process.
; Closure reel uncoils clockwise.
1
Installation
to the
4
is secure and
4
, control boxes
2
.
1
.
2
.
3
to lock firmly into place.
2
2
from its packaging and remove
1
of articulated shaft and tilt bearing
8
onto reel mount . Note the coiling
1 2
3
2
3
4
5
7
10