Parkside Performance PPFS 1250 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 16

NOTE
The orbital action enhances the sawing
u
speed, but the quality of the saw cut
deteriorates.
If you increase the level of the orbital action,
u
the vibration will also increase.
(Fig. F)
Set the orbital action level using the orbital
o
action control lever
Position Description
a
no orbital action
b
orbital action at a low level, with
good balance of stroke rate and
quality of the saw cut
c
orbital action at a high level,
with highest stroke rate, but low
quality of the saw cut
˜ Connecting/disconnecting the
detachable mains cord
(Fig. H)
m CAUTION! RISK OF INJURY!
Always unplug the power plug from
u
the socket-outlet before connecting or
disconnecting the detachable mains cord
to or from the product.
NOTE
Rotate the coupler
u
mains cord to lock or unlock the
[ ]
connection.
L
Connecting the mains cord
1. Insert the coupler
[
handle until it stops.
[ 8 ]
14 GB
.
3 ] [
[
of the detachable
[ ]
into the socket at the rear
]
2. Rotate the coupler
it (Fig. L).
3. Check if the coupler
pulling it lightly without any rotation.
Disconnecting the mains cord
1. Rotate the coupler
unlock it (Fig. L).
2. Disconnect the coupler
the rear handle
˜ Switching on and off
Before switching on: Connect the mains
o
plug to the socket-outlet.
[ ]
After switching off: Disconnect the mains
o
plug from the socket-outlet.
[ ]
m CAUTION! RISK OF INJURY!
Always wear protective gloves when
handling or working with the product.
m CAUTION! RISK OF INJURY!
Before switching on the product: Ensure
u
the saw blade is not in contact with the
workpiece.
Ensure your stance is stable. Always hold the
u
product's front
with both hands while working (Fig. I).
]
Keep your hands away from the saw blade
u
when the product is in operation.
During operation, you can choose between
o
instantaneous and continuous operation.
Instantaneous operation (Fig. E)
Switching on:
Switching off:
Continuous operation (Fig. E)
Start:
to the position to lock
[ ]
is securely installed by
[ ]
to the position to
[ ]
from the socket at
[ ]
.
[ 8 ]
and rear handle
[ 2 ] 8 ] [
Press and hold the on/off
switch .
[ ]
Release the on/off switch
Press and hold the on/off
switch . Simultaneously,
[ ]
push in the switch lock
Then release the on/off
switch.
firmly
.
[ ]
.
9 ] [