Selve commeo Receive Up/Down Betriebsanleitung Seite 37

Putting into operation/setting radio reception
Note for settings under point 6.2.: The drive/receiver must be
selected for these settings with a transmitter in SELECT mode (sta-
tus LED slowly flashes orange). After the setting has been config-
ured, the drive/receiver is still selected (see point. 6).
6.2.2. Programming/deleting transmitters
To programme or delete a transmitter, select the required channel
and press the PROG button for 1 second. The status LED lights up
green to indicate that the transmitter has been programmed. If the
status LED lights up red, this indicates that the transmitter has been
deleted.
1 s
6.2.3. Deleting the transmitter table in the receiver
To delete the transmitter table in the receiver, press the
PROG button on the transmitter for 6 seconds. All trans-
mitters that have been programmed in the receiver are
deleted. The receiver is deleted from the transmitter.
6 s
Note: This triggers an error message if there are any more pro-
grammed transmitters!
If this receiver moves in operating mode over a transmitter which is
still programmed, the transmitter will no longer receive a response
and will acknowledge this with an error message.
Status LED transmitter = green transmitter is
Status LED transmitter = red transmitter has
37
programmed
been deleted
EN