Selve commeo Receive Up/Down Betriebsanleitung Seite 38

Putting into operation/setting radio reception
Note for settings under point 6.2.: The drive/receiver must be
selected for these settings with a transmitter in SELECT mode (sta-
tus LED slowly flashes orange). After the setting has been config-
ured, the drive/receiver is still selected (see point 6.).
6.2.4. Resetting the receiver to the factory settings
To reset a receiver to the factory settings, press the PROG
button on the transmitter for 9 seconds. All settings are
reset to the factory settings. Transmitters and end posi-
tions are now no longer stored in the drive. The receiver is
deleted from the transmitter.
9 s
Note: This triggers an error message if there are any more pro-
grammed transmitters!
If this receiver moves in operating mode over a transmitter which is
still programmed, the transmitter will no longer receive a response
and will acknowledge this with an error message.
6.2.5. CONFIGURATION mode (only for authorised qualified per-
sonnel)
In configuration mode, you can set the functions of the radio drives
and receivers. The functions that can be set depend on the type of
drive/receiver. You can find more detailed information on configura-
tion mode in the document 'Configuring radio drives and receivers',
which is available to download at www.selve.de
6.3. Transmitter functions
Transmitter and receiver are in operating mode.
Intermediate positions
Refer to the transmitter manual for details about setting and calling
up the intermediate positions.
Deleting the receiver list in the transmitter
To delete the receiver lists from a transmitter, press and hold the
SELECT and PROG buttons simultaneously for 9 seconds. All receiv-
ers will then be deleted from the transmitter.
9 s
38