Selve commeo Receive Up/Down Betriebsanleitung Seite 26

Operation on commeo Receive Up/Down
Setting the runtime
The LED lights up orange while the runtime is being set. The move-
ment is interrupted once to indicate that the runtime has been set.
To set the runtime, always first move down to the lower end point
to start programming the runtime. Then move up to the upper end
point to complete the setting.
Operation
6 s
0.5 s
3 s
0.5 s
3 s
Movement
Press the movement buttons
and
onds.
Note: Can be omitted during the
initial installation.
Move the shutter down to the
lower end point using the move-
ment button . If the drive stops
by itself, stop the commeo Receive
Up/Down with the movement but-
ton .
Press the movement buttons
and
onds.
Move the shutter up to the upper
end point using the movement
button . If the drive stops by
itself, stop the commeo Receive
Up/Down with the movement but-
ton .
Press the movement buttons
and
onds. The runtime has now been
set. Perform a test run.
26
simultaneously for 6 sec-
simultaneously for 3 sec-
simultaneously for 3 sec-