Commissioning/start-up
Switching ON/OFF
NOTE
Electrical units must be disconnected from the power supply immediately in an emergency.
For units with a power plug, the plug must be accessible so that it can be pulled out.
For units with a power cable for permanent connection, suitable measures must be taken to
ensure that the unit can be disconnected from the power supply immediately.
Switching on: Plug the power plug into the outlet. If the outlet is switchable, switch on the out-
let if necessary.
• System without Controller OASE Switch: The lights are switched on.
• System with Controller OASE Switch: The green status LED on the controller lights up. Lights
connected to the controller can be controlled via the "OASE Switch" app.
Switching off: Pull the power plug out of the outlet or switch off the outlet.
• System with Controller OASE Switch: The Controller OASE Switch can be switched on perma-
nently. The lights connected to the controller are controlled via the "OASE Switch" app.
System with Controller OASE Switch
The "OASE Switch" app must be installed on your smartphone/tablet for commissioning and op-
erating the unit.
The operating systems iOS 12.5 (Apple) or Android 7.0 or newer are required to operate the App
on mobile devices.
Starting up the Controller OASE Switch
How to proceed:
1. If you have not already done so, install the "OASE Switch" app via the app store of your operat-
ing system (iOS or Android).
2. Check whether the Bluetooth function is switched on on your smartphone/tablet. If not,
switch it on.
3. Open the "OASE Switch" app and follow the instructions.
NOTE
Pairing between the Controller OASE Switch and an as yet unknown smartphone/tablet is only
possible within 5 minutes of switching on the controller.
If necessary, switch the controller off and on again to pair a new unit.
The blue status LED on the controller flashes when pairing mode is active.
The blue status LED on the controller lights up if the pairing was successful.
26