Elkron IM915AM Bedienungsanleitung Seite 3

3.0 INSTALLATION WITH BALL-JOINT
It's available (option) a ball-joint for wall or ceiling
installation. Equipped whit wall antitamper microcontact
and internal cable. Passage: for using and installation see
the product's instructions.
4.0 INSTALLATION WITHOUT BALL-JOINT
1
To remove sensor cover,
take out locking screw (if
fitted ) and press on fixing
snap.
3
3.P = Cable entry
(Force open required opening)
Holes for wall fixing
(to be forced open)
A = Holes for angle fixing
B = Holes for flat surface fixing
3.0 INSTALLATION WITH BALL-JOINT
It's available (option) a ball-joint for wall or ceiling
installation. Equipped whit wall antitamper microcontact
and internal cable. Passage: for using and installation see
the product's instructions.
4.0 INSTALLATION WITHOUT BALL-JOINT
1
To remove sensor cover,
take out locking screw (if
fitted ) and press on fixing
snap.
3
3.P = Cable entry
(Force open required opening)
Holes for wall fixing
(to be forced open)
A = Holes for angle fixing
B = Holes for flat surface fixing
To remove
printed circuit,
A
take out screw
A
Warning: Do not touch pyroelectric
sensor
P
P
A
B
4
A
B
A
To remove
printed circuit,
A
take out screw
A
Warning: Do not touch pyroelectric
sensor
P
P
A
B
4
A
B
A
5.0 LENS PATTERN OPTION
Der Sensor ist werkseitig mit der Linse für
die volumetrische Abdeckung ausgestattet.
1
To remove sensor
cover, remove
2
locking screw (if fitted)
and press on the fixing
clip while pulling the
cover away from the
base.
3
Remove the lens, locate the
P marks on the outside edge
in order select the lens
pattern you require. After
selecting the pattern place
the lens back (before
replacing the lens cut the
reference pin on the edge of
the lens) with the chosen
lens pattern downwards.
A
Notice: The lens rotation (to
change the detector
coverage) doesn't influence
the microwave coverage
A
field.
A
3
5.0 LENS PATTERN OPTION
Der Sensor ist werkseitig mit der Linse für
die volumetrische Abdeckung ausgestattet.
1
To remove sensor
cover, remove
2
locking screw (if fitted)
and press on the fixing
clip while pulling the
cover away from the
base.
3
Remove the lens, locate the
P marks on the outside edge
in order select the lens
pattern you require. After
selecting the pattern place
the lens back (before
replacing the lens cut the
reference pin on the edge of
the lens) with the chosen
lens pattern downwards.
A
Notice: The lens rotation (to
change the detector
coverage) doesn't influence
the microwave coverage
A
field.
A
3
Unclip the lens by pressing the
clips A.
A
the
2
Active zone
Unclip the lens by pressing the
clips A.
A
the
2
Active zone
Reference notch
Without cut
Volumetric lens
1 cut
Masking lens
2 cuts
Long distance lens
Reference notch
Without cut
Volumetric lens
1 cut
Masking lens
2 cuts
Long distance lens