Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. After charging, disconnect the end (7a) of the
USB charging cable (7) from the rechargeable
battery connector (1c) and unplug the end (7b)
of the USB charging cable (7) from the USB
port.
Undervoltage warning
The lights (1f) start flashing when the rechargea-
ble battery is almost empty. Charge the quadro-
copter (1) as soon as you notice this.
Transferring data (Fig. F)
Photographs and film are stored on the microSD
card (6). The data is transferred to a computer or
device with a USB port (such as a television) as
follows:
1. The microSD card (6) is located in a specific
slot in the quadrocopter (1d). Press down on
the microSD card (6) and remove it from the
port (1d).
2. Slide the microSD card (6) fully into the mi-
croSD card USB stick (5), as shown in Figure F.
NOTE: Take care to insert the microSD
card (6) properly. It needs to be almost
completely inside the microSD card USB
stick (5).
3. Insert the microSD card USB stick (5) into the
USB port of a computer.
4. The computer will recognise the microSD card
USB stick (5) and you will then be able to copy
the data to the computer.
Suitable areas for flying the
quadrocopter
For ideal flight conditions, the following criteria
should be met:
• Calm conditions, up to force 2 winds.
• Check local weather report for current weather
conditions and forecast changes.
• People must remain a safe distance (5 metres)
from the quadrocopter when it is taking off.
• Be aware of obstacles before flying, and move
them out of the way if possible, or maintain a
safe distance from them (>5 metres).
• Observe your surroundings and look out for
variables such as pedestrians, cyclists and
traffic/vehicles.
• Find a large, wide, open area without obstruc-
tions; pay particular attention to buildings,
crowds, power lines and trees.
• For aerobatic activities, such as loops, there
should be a space of approx. 10m in all direc-
tions.
• Take care to select a dry and rain free envi-
ronment. Do not fly the quadrocopter in poor
or damp weather conditions (e.g. in snow, fog
or at night). The quadrocopter must only be
operated when visibility is good.
• The quadrocopter must be operated in tempera-
tures between 10°C and 45°C.
• Pay attention to the restrictions in the Drone
Ordinance in respect of prohibited areas (see
the section on "Safety information").
Flight preparation
Pay attention to the following, before you start
flying the quadrocopter (1):
1. Always place the quadrocopter (1) on an even
surface for take off.
NOTE: The camera lens and red control
lights (1f) indicate the front of the quad-
rocopter (1). The green control lights (1f)
indicate the rear of the quadrocopter (1).
2. Always move the throttle (2d) and control lever
(2e) slowly and carefully with sensitivity.
3. Keep your attention continuously focused on the
quadrocopter during the flight (1)!
CAUTION: Always keep the
quadrocopter in sight during flight
operations!
4. Do not hang any loads on the Quadrocopter
(1).
CAUTION: Check the rotor protection
(1e) (Fig. B) before each flight to ensure
that it is secure and undamaged.
Otherwise there is a risk of the rotor blades (1g),
(1h) being damaged during a flight and thus
causing injury.
GB
15
Werbung
