lidl QC-4706 Gebrauchsanweisung Seite 12

• The USB charging cable may only be used in
dry, closed indoor areas. The USB charging
cable and battery must not get damp or wet.
• Never carry rechargeable batteries in trouser
pockets or carrier bags. Watch out for sharp
or angular objects which could damage your
battery.
• If the quadrocopter has been subjected to a
strong blow, store it for the next 30 minutes in
a very secure place (e.g. in a metal box). Pay
attention to whether the rechargeable battery
swells and/or overheats.
• Never try to manipulate, modify or repair the
rechargeable battery.
• Never damage the outer shell of the battery.
Do not cut the foil sheath. Do not pierce the
rechargeable battery with sharp objects. There
is a risk of fire and explosion!
Foreseeable misuse
Take care not to misuse the item in the following
ways:
• Do not operate the quadrocopter in unsuitable
weather or environmental conditions (e.g. in
rain, snow, fog or at night).
• Do not operate the quadrocopter in too small
a space (under 6 x 4m), or if there are objects,
people or animals within a radius of 5m.
• Never fly over flight exclusion zones, prohibited
areas or official installations, and always com-
ply with the minimum distances from such areas
(see also "Safety information").
• Do not invade the personal space of others
(e.g. with the camera function).
• Do not give the item to anyone under the age of
14 years.
• Attaching loads or making modifications in any
way is strictly prohibited.
• Do not operate the quadrocopter if there are
loose or defective parts (e.g. after a collision or
crash).
14 GB
Inserting the batteries into the
remote control (Fig. D)
CAUTION: Observe the following
instructions to avoid mechanical
and electrical damage.
Insert the batteries enclosed (8) into the battery
compartment (2m) of the remote control (2).
Inserting the batteries
1. Using the Phillips screwdriver (9), loosen the
screw (2k) of the battery compartment lid on
the back of the remote control (2) and remove
the lid (2l).
2. Carefully insert the two 1.5V LR6-type batteries
(8) into the battery compartment (2m). The bat-
teries (8) must be fully inserted into the battery
compartment (2m).
CAUTION: Check the positive/negative
poles of the batteries (8) and ensure that
they are inserted correctly, as marked on
the bottom of the battery compartment
(2m).
3. Retighten the screw (2k) on the battery compart-
ment lid on the back of the remote control (2).
Replacing the batteries
CAUTION: Observe the following
instructions to avoid mechanical
and electrical damage.
When the batteries (8) are no longer working, re-
place them as described in the instructions above.
Remove the batteries (8) that are in the device
before inserting new ones (8).
Charging the battery (Fig. E)
1. Connect the cable end (7a) of the USB
charging cable (7) to the rechargeable battery
connector (1c) on the quadrocopter (1).
2. Plug the other end of the USB charging cable
(7b) into a USB port of a computer that is
switched on, or into a charger with a USB port.
NOTE: Charging takes about 45 minutes.
3. The battery charge indicator of the USB
charging cable (7) lights up, as soon as the
rechargeable battery of the quadrocopter (1) is
fully charged.