Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Dispose of batteries when discharged. We recommend covering the poles with an adhesive strip to protect
against a short circuit. Do not open the battery.
• Dispose of batteries according to local regulations. Return batteries to a used battery collection point where
they can be recycled in an environmentally friendly manner. Ask your local waste disposal company about this.
16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your product failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Tool cuts out
Motor runs, but blades do not
move
Cutting blades hot
Battery does not charge
Possible cause
• Internal wiring defective
• On/off switch defective
• Internal fault
• Blades are blunt
• Blades are deformed
• Excessive friction due to
lack of lubricant
• Power supply unit is not
connected to the mains
• Power supply is defective
• Battery is defective
www.scheppach.com
Remedy
• Contact dealer / customer service
• Contact dealer / customer service
• Contact dealer / customer service
• Have blades sharpened
• Have blades checked
• Lubricate blades
• Connect the power supply unit to the
mains
• Contact dealer / customer service
• Contact dealer / customer service
GB | 31
Werbung
