74 | Installation
WARNING
Storage system | Installation manual
Risk of injury due to sharp edges
The components have sharp edges, which can cause
hand injuries if they are not handled carefully.
Wear protective gloves
Mount the components with two people
Prerequisites
The bracket for the BMM is attached to the front of
the battery cover.
The BMM terminals are facing upwards
▶
Procedure
1. Use the 2.5-mm Allen key to screw the BMM to the
bracket on the battery cover with four M4 rounded
head screws and washers so that the module
terminals are facing upwards. (Tightening torque
0.5 Nm)
English
Bosch Power Tec GmbH