Installing The Housing Feet - Bosch BPT-S Hybrid Installationsanleitung

English
Bosch Power Tec GmbH
■
The storage system is unpacked.
5.4

Installing the housing feet

Prerequisites
Before installing the feet, the housing stands must

be set to the required length. A minimum distance
of 50 mm is required between the upper edge of the
guard plate and the underside of the storage
system.
Empty housing

▶
Procedure
1. Tip the housing onto its right-hand side
2. Right-hand side: Pull both stands out to 63.5 mm
This creates a distance of 50 mm between the
underside of the storage system and the guard
plate.
5.1: Distance of 50 mm between the storage system and
guard plate
3. Install one foot each on both the front and rear
housing stands
Delivery and positioning | 53
Storage system | Installation manual