Connecting A Pv Sensor - Bosch BPT-S Hybrid Installationsanleitung

108 | External cabling
Storage system | Installation manual
[5]
USB
USB ports, e.g. for updating firmware
7.3.1

Connecting a PV sensor

▶
Procedure
1. Remove the connector from the CAN Open
terminal
2. Open the connector
3. Remove the resistor
4. Assign the connector pins
7.6: PV sensor: Pin assignment
PIN Assignment
1 CAN high
2 CAN low
3 CAN ground
4 not assigned
5 Sensor 24 V
6 Sensor 0 V
7 not assigned
8 not assigned
5. Reassemble the connector
English
Bosch Power Tec GmbH