Attaching The Battery Type Plate - Bosch BPT-S Hybrid Installationsanleitung

English
Bosch Power Tec GmbH
4. Pull both halves of the guard plate apart again so
that the four housing stands fit into the openings
on the plates. (Guard plate protrudes at the sides
and the front)
5. Check: When pulling the two halves apart, the
positioner must click into place on the end of the
plate.
6. Use the 4 mm Allen key to screw both halves of the
guard plate in place with M5 Allen screws and
washers (3) (tightening torque 2.7 Nm)
6.39: Screw the two halves of the guard plate in place
■
The guard plate is installed.

6.17 Attaching the battery type plate

▶
Procedure
1. Glue the type plate for the batteries installed to
the designated area on the system type plate.
Info
The battery capacity installed that is stated on

the battery type plate depends on the number of
batteries installed.
2 batteries = 4.4 kWh

3 batteries = 6.6 kWh

(3)
Storage system | Installation manual
Installation | 99