Battery Display; Charging The Batteries - ROBBE-Futaba ATTACK T2ER Bedienungsanleitung

4.

Battery display

have very little driving or flying time left. If the red
LED begins to flash, prepare to land or bring your
model to a halt immediately. Recharge the transmit-
ter batteries straight away, or fit new batteries.
If the capacity of the receiver battery is beginning to
run down, the servo movements will slow down.
Should this happen, cease operation as soon as pos-
sible and re-charge or change the receiver battery

Charging the batteries

Charge socket
Instruction manual
Attack T2ER
There are two
LEDs to show the
power level of the
transmitter batte-
ries. If the capacity
is adequate, both
LEDs will light up.
Should the green
LED go out, this
indicates that you
Lader 5r charger
Transmitter
Switch 'OFF'
F 1415
F 1418
12
5. Charging NC-batteries
We recommend the use of our Lader 5r charger,
robbe Order No. 8308 for charging NC batteries. The
following charge leads are required: No. F1415 for
the transmitter, and F1418 for the receiver battery.
The charge current is 60 mA for both batteries, the
charge period 14 hours. The transmitter may only be
charged with the switch in the "OFF" position.
Always take care to use the correct charge current
(1/10 of the nominal capacity) when charging NC bat-
teries.
PLEASE NOTE: Dry batteries cannot be re-char-
ged - danger of explosion
The maximum permissible charge current for the
transmitter charge socket is 1 A.
Always connect the charge lead to the charger
first to avoid short circuits.
Receiver battery
Order No.
F 2210 / F2211