Fronius Acctiva Easy 1202 Bedienungsanleitung Seite 25

Safety measures
-
in normal opera-
tion
-
-
-
-
-
-
-
EMC Device Devices in emission class A:
Classifications -
-
Devices in emission class B:
-
EMC device classification as per the rating plate or technical data.
EMC measures In certain cases, even though a device complies with the standard limit values for
emissions, it may affect the application area for which it was designed (e.g. when
there is sensitive equipment at the same location, or if the site where the device
is installed is close to either radio or television receivers).
If this is the case, then the operating company is obliged to take appropriate ac-
tion to rectify the situation.
Data protection The user is responsible for the safekeeping of any changes made to the factory
settings. The manufacturer accepts no liability for any deleted personal settings.
Maintenance and Under normal operating conditions, the device requires only a minimum of care
repair and maintenance. However, it is vital to observe some important points to ensure
it remains in a usable condition for many years.
-
-
Maintenance and repair work must only be carried out by authorised personnel.
Use only original replacement and wearing parts (also applies to standard parts).
It is impossible to guarantee that bought-in parts are designed and manufactu-
Chargers with PE conductors must only be operated on a mains supply with a
PE conductor and a socket with an earth contact. If the charger is operated
on a mains supply without a PE conductor or in a socket without an earth
contact, this will be deemed gross negligence. The manufacturer shall not be
held liable for any damage arising from such usage.
Only operate the charger in accordance with the degree of protection shown
on the rating plate.
Under no circumstances operate the charger if there is any evidence of da-
mage.
Ensure that the cooling air can enter and exit unhindered through the air
ducts on the charger.
Arrange for the mains and charger supply to be checked regularly by a quali-
fied electrician to ensure the PE conductor is functioning properly.
Any safety devices and parts that are not functioning properly or are in im-
perfect condition must be repaired by a qualified technician before switching
on the charger.
Never bypass or disable protection devices.
After installation, a freely accessible mains plug is required.
Are only designed for use in industrial settings
Can cause line-bound and radiated interference in other areas
Satisfy the emissions criteria for residential and industrial areas. This is also
true for residential areas in which the energy is supplied from the public low-
voltage mains.
Before switching on, always check the mains plug and cable as well as char-
ger leads and charging terminals for any signs of damage.
If the surface of the device housing is dirty, clean with a soft cloth and sol-
vent-free cleaning agent only
English
25