Working Instructions; Activate/Deactivate The Bluetooth Function On The Battery Pack - Parkside Performance Pabsp 20 Li C3 Kurzanleitung/Originalbetriebsanleitung

˜ LED work light
This product is equipped with a LED work light
the immediate working area to improve visibility in poorly lit
areas.
The LED work light lights up automatically as soon as the
o
product is switched on.
NOTE
The LED work light stays on for an additional approx.
u
10 seconds after switching off the product.
˜ Trial run
NOTE
Always carry out a no-load trial run before starting work
u
and after every accessory tool replacement. Switch
the product off immediately if the accessory tool is not
running smoothly, if considerable vibration occurs or if
you hear abnormal noises.
Before operating the product, check whether the accessory
o
tool is correctly positioned, i.e. centred in the chuck
Screw bits are labelled according to their dimensions and
o
their shape. If you are uncertain, always check whether the
bit fits tightly in the screw head without any free play.
˜ Working instructions
Torque
Smaller screws/bits can be damaged if you set the torque
o
or rotational speed too high.
Hard screw joints (in metal)
Particularly high torque occurs, for example in metal screw
o
joints made using drive sockets. Select a low rotational
speed.
Soft screw joints (e.g. in soft wood)
Again, use a low rotational speed, e.g. to avoid damaging
o
the surface of the wood upon contact with the screw head.
Use a countersink.
Drilling in wood, metal and other materials
Use a high speed for drill bits with small diameter and a
o
low speed for drill bits with large diameter.
Select a low speed for hard materials and a high speed for
o
soft materials.
Secure or fasten the workpiece in a clamp or vice (if
o
possible).
36 GB/IE
Mark the spot where you want to drill using a centre punch
o
or nail. Select a low rotational speed when starting.
to illuminate
[ ]
Pull the rotating drill bit from the hole repeatedly to remove
o
dust and chips and clear the hole.
Drilling in metal
Use a metal drill (HSS). For optimum results, cool the
o
drill bit with cooling lubricant (cutting oil). Metal drill bits
can also be used to drill into plastics. Start with a 3 mm
diameter drill bit and then increase the size until the desired
hole diameter is achieved.
Drilling in wood
Use a wood drill with a lathe centre.
o
Deep holes: Use an auger bit.
Large-diameter holes: Use a Forstner bit.
Small screws can be screwed directly into soft wood.
Belt clip (fig. J)
m
CAUTION! RISK OF INJURY!
.
[ 1 ]
Before hanging the product in the belt: Push the rotation
u
direction switch
This prevents the product from being switched on
accidentally.
The belt clip
o
belt or pocket.
˜ Activate/deactivate the Bluetooth
function on the battery pack
NOTE
The Bluetooth function is only available for Parkside
u
smart batteries PAPS 204 A1 and PAPS 208 A1. The
included battery pack PAP 20 B1 does not feature the
Bluetooth function.
Press and hold the
o
3 seconds to activate the Bluetooth function. The orange
charging level LED lights up. The Bluetooth function is
enabled.
Release the
o
Press and hold the
o
10 seconds to deactivate the Bluetooth function. The
orange charging level LED goes off. The Bluetooth function
is deactivated. In the Lidl Home app the battery pack is
shown as offline.
to the centre position (lock).
5 ] [
allows the power tool to be hooked on
9 ] [
button on the battery pack for
button.
button on the battery pack for