Switching On And Off - Parkside Performance Pabsp 20 Li C3 Kurzanleitung/Originalbetriebsanleitung

m
CAUTION! RISK OF INJURY!
After the product has been switched off, the accessory
u
tool continues moving for some time. Do not touch the
accessory tool and do not attempt to brake it.
This product is equipped with an automatic spindle lock to open
or close the chuck with the chuck sleeve
[ 1 ]
1. Open the chuck: Turn the chuck sleeve in a
counter-clockwise direction (Fig. E).
2. Insert a suitable accessory tool into the chuck as deep as
required.
3. Close the chuck: Hold the accessory tool in position. Turn
the chuck sleeve in a clockwise direction.
NOTES
This product is equipped with a Röhm drill chuck with an
u
anti-lock function.
If you attempt to open the fully opened chuck further, the
u
anti-lock function will be activated to protect the chuck.
When the anti-lock function is activated, the chuck
u
cannot be closed by turning the chuck sleeve in a
clockwise direction. A ratcheting sound will be produced
when you attempt to close the chuck.
Deactivating the chuck's anti-lock function: Turn the
u
chuck sleeve in a clockwise direction by a certain extent.
Then, turn the chuck sleeve suddenly and quickly in a
counter-clockwise direction.
Repeat this action if the anti-lock function is still active.
When the anti-lock function is deactivated, you should
be able to close the chuck without ratcheting sounds.
˜ Gear selection
m
ATTENTION! RISK OF PRODUCT DAMAGE!
Do not operate the gear selector
product has come to a standstill.
Change the gear by sliding the gear selector forwards or
o
backwards (fig. F).
1 gear:
st
Suitable for:
Speed:
Torque:
.
2 ] [
until the
4 ] [
Screwing
Low
High
2 gear:
nd
Suitable for:
Speed:
Torque:
˜ Setting the rotating direction
m
ATTENTION! RISK OF PRODUCT DAMAGE!
Do not operate the rotation direction switch
until the product has come to a standstill.
Change the direction of rotation by pressing the rotation
o
direction switch towards the left or right (fig. G).
When the rotation direction switch is in the middle position,
o
the on/off switch is locked.
6 ] [
˜ Torque control
This product is equipped with a torque control that disengages
the spindle when a predefined torque is exceeded.
The torque can be adjusted by turning the torque sleeve
o
(fig. H).
Small screws or soft materials: Select a low level.
o
Large screws, hard materials or removing screws: Select a
o
high level.
For drilling operation: Turn the torque sleeve to the
o
position.
˜ Switching on and off
NOTE
The on/off switch cannot be locked.
[ 6 ]
Switching on: Press and hold the on/off switch.
o
Regulate the speed as required (see "Speed control")
(fig. I).
Switching off: Release the on/off switch.
o
˜ Speed control
By using the on/off switch
o
control the speed:
Pressure
Gentle pressure
Greater pressure
Drilling
High
Low
5 ] [
, you can progressively
6 ] [
Speed
Lower speed
Higher speed
GB/IE
[ 3 ]
35