Operation - Parkside Performance Pabsp 20 Li C3 Kurzanleitung/Originalbetriebsanleitung

˜ Positioning the battery charger
The battery charger
[ ]
o
mounted on a wall.
Wall mounting
1. Drill 2 holes in the wall with a spacing of 76.2 mm.
2. Place 2 dowels into the holes.
3. Place 2 round-head screws with screw head diameter
of 7 to 8 mm into the dowels. Leave the screw head
protruding at a distance of approx. 8 mm from the wall.
4. Place the battery charger onto the screws using the
openings at the back of the battery charger. The charging
control LEDs (green and red
[ ]
the lower end of the battery charger.
˜ Operation
˜ Attaching/removing the battery
pack
m
CAUTION! RISK OF INJURY!
Always lock the on/off switch
u
starting by moving the rotation direction switch
the centre position (Lock).
NOTE
When you insert a smart battery pack (model no.
u
PAPS 204 A1, PAPS 208 A1) into the product and press
the on/off switch for the first time, the connection status
LED flashes 3×.
[ ]
Removing the battery pack: Press the battery pack
o
release button . Remove the battery pack (Fig. D).
[ ]
Attaching the battery pack: Align the battery pack
o
to the handle and slide it into it. Ensure the battery pack
clicks noticeably in place.
The battery pack can only be inserted into the product in
one direction.
˜ Checking the battery pack charging
level
(Fig. B)
Check battery pack charging level: Press the
o
button . The charging level LEDs
[ ]
LED
Red/orange/green
Red/orange
Red
34 GB/IE
can be used either free-standing or
) have to be located on
[ ]
to avoid accidental
[ 6 ]
into
5 ] [
light up:
[ ]
Charging level
Maximum
Medium
Low
˜ Charging the battery pack
(Fig. C)
NOTE
The battery pack may be charged at any time
u [ ]
without reducing its life.
Interrupting the charging process does not damage the
u
battery pack.
Charge the battery pack before operation when it is at
o
medium or low charging level.
The charging control LEDs (green
o
the status of the charger
LED
Red LED lights up
Green LED lights up
Green and red LED flashing
Red LED flashing
Green LED lights up (without
battery pack)
1. Insert the battery pack into the charger.
2. Connect the mains cord with mains plug
to the socket-outlet.
3. When the battery pack is fully charged: Remove the
battery pack from the charger. Then disconnect the mains
plug of the charger from the socket-outlet.
˜ Attaching/removing the accessory
tool
m
CAUTION! RISK OF INJURY!
Accessory tools can be sharp and may become hot
during use. Always wear protective gloves when
handling accessory tools!
m
WARNING!
Always switch the product off, remove the battery
pack and let the product cool down before
[ ]
making any adjustments!
m
CAUTION! RISK OF INJURY!
Keep your hands away from the accessory tool when
u
the product is in operation.
and red ) indicate
[ ] [ ]
and the battery pack:
[ ]
Status
Battery pack charges
Battery pack fully
charged
Battery pack defective
Battery pack too cold
or too warm
Charger ready
of the charger
[ ]