Safety Information For The Saw­blade; Safe Working - Parkside Performance PPHKSA 40-Li A1 Originalbetriebsanleitung

not covering the saw blade. An unpro-
tected saw blade that is still running will
move­the­saw­in­the­direction­opposite­
of­the­cutting­direction­and­cut­whatever­
is in its way. Pay attention to how long
the saw blade remains running.
Safety information
for the saw­blade
This information on the saw blade complies
with­standard­DIN­EN­847-1:2017.
The tool may only be used by
trained,­experienced­people­who­
know how to handle tools.

Safe working

•­The­maximum­speed­stated­on­the­tool­
must­not­be­exceeded.­If­indicated,­the­
speed range must be complied with.
•­Circular­saw­blades­with­cracks­in­them­
must­be­taken­out­of­service­(repair­is­not­
permitted).
•­Tools­with­visible­cracks­must­not­be­used.
•­Tools­must­be­cleaned­regularly.
•­Tool­parts­made­of­light­metal­alloys,­
e.g. resin, may only be cleaned with sol-
vents­that­do­not­impair­the­mechanical­
properties of these materials.
•­Tools­and­tool­bodies­must­be­tightened­
in such a way that they cannot become
loose during operation. Please note the
information on assembly.
Tighten the clamping screw holding the
saw­blade­in­place­hand-tight­using­the­
enclosed­hex­key.
•­Extending­a­spanner­or­tightening­with­the­
help of hammer blows is not permitted.
•­The­tightening­surfaces­on­the­saw­blade­
must­be­cleaned­to­remove­any­dirt,­
grease, oil and water.
•­Use­original­spare­parts­from­the­manu-
facturer to ensure safe use, see the sec-
tion­"Spare­parts/accessories".
•­Maintenance­work­and­modifications­to­
circular saw blades should only be per-
formed by a professional, i.e. a person
with­specialist­training­and­experience­
who is familiar with the design require-
ments and the necessary safety steps.
Cleaning
•­Remove­any­dirt,­such­as­resin,­from­the­
saw­blade­using­only­solvents­that­do­
not impair the mechanical properties of
the saw blade.
•­Try­to­clean­resinous­surfaces­with­a­
damp, lukewarm cloth that has been
wrung­out­well.­Make­sure­that­no­liquids­
can get into the interior of the housing!
Alternatively,­you­can­use­a­special­
cleaner­(resin­solvent)­or­multispray.­
Please take notice of the safety informa-
tion­and­instructions­provided­by­the­
manufacturer of the special cleaner/
multispray.
Maintenance
•­Check­the­saw­blade­for­obvious­defects­
after each use and replace a blunt or
bent blade or one which has been dam-
aged in some other way.
•­Maintenance­work­on­the­saw­blades,­
such as repair or regrinding, should be
performed by a professional.
Storage
Store the saw blade in a dry and dustproof
location and out of reach of children.
GB MT
35