Parkside Performance PABSP 20 Li C3 Bedienungsanleitung Und Originalbetriebsanleitung Seite 18

˜ Checking the battery pack
charging level
(Fig. B)
Check battery pack charge level: Press the
button . The charging level LEDs
[ ]
light up:
LED
[ ]
Red/orange/green
Red/orange
Red
˜ Charging the battery pack
(Fig. C)
NOTE
The battery pack
u
any time without reducing the life.
Interrupting the charging process does not
u
damage the battery pack
Charge the battery pack
when it is at medium or low charging level.
The charging control LEDs (green
red ) indicate the status of the charger
[ ]
and the battery pack
LED
Red LED lights up
Green LED lights up
Green and red LED
flashing
Red LED flashing
Green LED lights up
(without battery pack)
Insert the battery pack
charger .
[ ]
Connect the power cord with power plug
of the charger to the socket.
[ ]
16 GB
[
Charging level
Maximum
Medium
Low
may be charged at
[ ]
.
[ ]
before operation
[ ]
and
[ ]
:
[ ]
Status
Battery pack
charges
Battery pack fully
charged
Battery pack
defective
Battery pack too
cold or too warm
Charger ready
into the
[ ]
When the battery pack
charged: Remove the battery pack from
the charger
plug of the charger from the socket.
[ ]
]
˜ Attaching/removing the
accessory tool
m CAUTION! RISK OF INJURY!
Accessory tools can be sharp and
may become hot during use. Always
wear protective gloves when handling
accessory tools!
m WARNING!
Always switch the product off, remove
the battery pack
product cool down before making any
adjustments!
m CAUTION! RISK OF INJURY!
Keep your hands away from the accessory
u
tool when the product is in operation.
[ ]
m CAUTION! RISK OF INJURY!
After the product has been switched off, the
u
accessory tool continues moving for some
time. Do not touch the accessory tool and
do not attempt to brake it.
This product is equipped with an automatic
spindle lock to open or close the chuck
the chuck ring
2 ] [
Open the chuck
a counter-clockwise direction (Fig. E).
Insert a suitable accessory tool into the
chuck as deep as required.
1 ] [
Close the chuck
tool in position. Turn the chuck ring
clockwise direction.
[ ]
is fully
[ ]
. Then disconnect the power
[ ]
and let the
[ ]
.
: Turn the chuck ring
1 ] [
: Hold the accessory
1 ] [
with
1 ] [
in
2 ] [
in a
2 ] [