Troubleshooting; Storage; Machine Washing And Cleaning; Disposal Of Packaging And The Machine At The End Of Its Service Life - Vari Rbs-700D Bedienungsanleitung

2.5.6.1 Troubleshooting

Problem
The work tool will not rotate
The revolutions of the work tool are dropping
The attachment drive will not stop
Another defect
Table 17: Troubleshooting

2.5.6.2 Storage

Before storing the machine for a longer time, we recommend to do the following:

Remove any dirt from the machine.

Repair any paint damage.

Lubricate the machine as recommended, see Table 10.
Prevent unauthorized persons from access to the machine. Protect the machine against climatic conditions but do not use impermeable
protection to prevent excessive corrosion it may cause.

2.5.6.2.1 Machine Washing and Cleaning

When washing and cleaning the machine, proceed so as to observe valid provisions and laws regarding protection of water courses and
other water resources against pollution or contamination by chemical agents.

You can use the pressure washer to wash parts of the machine.

After washing, always dry the machine and lubricate, if needed, moving parts in accordance with instructions in Chapter
2.5.3 Machine Lubrication.

2.5.6.3 Disposal of Packaging and the Machine at the End of its Service Life


When you unpack the machine you are bound to dispose of the packaging material according to national laws and
decrees concerning waste disposal.
When disposing of the machine at the end of its service life, we recommend proceeding as follows:
1) Demount from your machine all the parts that may still be used.
2) Drain oil from the engine into a suitable closing container and dispose it in a waste collection centre
3) Demount plastic parts and non-ferrous metal parts.
4) The remaining machine and its removed demounted parts are to be disposed of according to national laws and decrees
concerning waste disposal.

2.5.6.4 How to Order Spare Parts

These Operating Instruction do not include the list of spare parts.
For correct identification of your machine, you have to know the type designation (Type), serial identification number (№) and order
number (C№) stated on the machine nameplate, box, or in the warranty card. Only with this information it is possible to search correctly
for the designation of the respective spare part with your seller.
To search spare parts in the electronic catalogue of spare parts at http://katalognd.vari.cz, the first 10 characters of the identification
number № are sufficient. If you do not have Internet access, you can ask for the printed catalogue to be sent C.O.D.
45 The respective local authority will inform you of the disposal centre location.
Cause
The engine is not started
The adaptor drive clutch lever is not pressed
The attachment drive belt pulley is not engaged
The attachment drive belt is not tightened
Broken belt of the drive of the attachment
The belt of the drive of the attachment fell off
Broken attachment drive clutch cable.
Jammed bearings
other defect
The clutch is slipping
Blocked up clutch
Solution
Start the engine
Press the lever
Engage the pulley according to the instructions
contained in the operating instructions for the
attachment
Adjust the tension pulley
Replace the belt
Re-mount the belt
Visit a service facility
visit service - special fixtures needed
Visit a service facility
Adjust the clutch or visit a service facility
Visit a service facility
Visit a service facility
45 .
RBS-700D
27