EXFO FTB-500 Bedienungsanleitung Seite 462

Communicating Through TCP/IP over Telnet
Executing SCPI Commands Over Telnet
7. Click
To connect through TCP/IP over Telnet from a remote Linux client:
1. From your computer, right-click on the desktop, and then click Open
Terminal.
The command prompt is displayed in the Telnet editor window.
2. Connect to the TCP/IP Telnet Service by typing the
OPEN <IP_ADDRESS_OF_TELNET_SERVER> <PORT> command:
Example: open 10.192.2.45 5024
Note: Port 5024 is designated for sending SCPI commands in the Telnet protocol.
The connection is established when the message Connected to
Toolbox/IQS Manager is displayed in the Telnet editor window.
454
to close the session.
FTB-500