Telecom Behnke 43-9582C Anleitung Seite 31

2.5. Reset to default settings
▸ Disable the camera's power supply
▸ Press and hold the reset button ▸ Supply the
camera with power while pressing the
button
▸ When the LEDs start flashing (after approx. 15
- 30 seconds), you may let go of the key
The following settings must be restored after
reset:
▸ From Firmware version 11.2.53
▸ 1. Assign camera password
▸ 2. Powerline frequency: 50Hz
▸ 3. Advanced configurations
/Network/Network/ HTTP: set to casic
▸ deactivate „ZeroConf" Enabled
!
These settings should only be made
if you have sufficient knowledge of
the AXIS web frontend.
43-9582C - Remove the camera covers to press
the reset button.
www.behnke-online.de
Instructions IP camera 43-9582C
Configuration and Set-up
GB
31