Reset To Default Settings - Telecom Behnke 20-2940-IP Anleitung

IP camera Instructions
GB GB
Configuration and Set-up

2.5. Reset to default settings

▸
Disconnect the camera from the power supply
▸
Press and hold the reset key
▸
Continue to hold the reset key and connect
the camera to the power supply
▸ Stop pressing the key when the LED starts
flashing (after approx. 15-30 seconds)
The following settings must be carried out
again after the reset:
For 20-2940-IP/21-2940-IP,
20-2941-IP/21-2941-IP, 43-2940, 50-2940-IP:
▸
1. Allocate camera password
▸
2. Capture mode: 4MP (2304x1728)
▸
3. Powerline frequency 50 Hz.
▸
4. System/Simple configuration/Network/
HTTP set to "Basic"
▸ 5. System/Simple configuration/Network/
ZeroConf
remove the check mark at "Enabled"
20-2940-IP/21-2940-IP,
20-2941-IP/21-2941-IP,
43-2940, 50-2940-IP
!
These settings should only be carried
out if the AXIS web front end is known
well enough.
28 www.behnke-online.com