Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Instructions IP camera 43-9582C
GB
Introduction
1.6. Connecting the IP camera to the
basic electronics 20-0001-BS, 20-0014-
BS, 20-0016-BS, 20-0005-BS
LAN connection
The LAN connection is usually made via
a patch cable
1
with an RJ-45 connector (inclu-
ded in the camera's scope of delivery).
When operated with the series 20 IP basic
electronics mentioned above, the network con-
nection can also be established via the series
20 basic electronics.
To do so, connect the camera module's RJ-45
connector to the "Network port with PoE" socket
of the Series 20 hybrid basic electronics.
It provides sufficient power to operate this
Behnke IP camera.
For connection, see page 29.
28
Power supply
Power for the Behnke IP camera is supplied via
the ethernet port (PoE). When operated with the
series 20 basic electronics mentioned above,
power for the camera is supplied via PoE from
the IP basic electronics. The power at the switch
port of the IP base electronics is only available
after the SIP intercom station has completed the
startup process.
If the camera is operated independently, all
items described in the technical specifications
of the camera must be observed.
www.behnke-online.de
Werbung
